Cisco 2 Chapter 3 Exam Answers links:
[FREE] Cisco 2 Chapter 3 Exam Answers | free!
Posted on 2-May-2021
RIP will advertise two networks to its neighbor. While configuring RIPv2 on an enterprise network, an engineer enters the command network What is the result of entering this command? The interface of the A destination route in the routing table is...
[ VIEW ANSWER ] [ Find Similar ]
[GET] Cisco 2 Chapter 3 Exam Answers
Posted on 6-May-2021
What two facts can be determined? Choose two. POST occurred normally. The boot process was interrupted. There is not enough RAM or flash on this router. A full version of the Cisco IOS was located and loaded. Which two statements are true about...
[ VIEW ANSWER ] [ Find Similar ]
CCNA 2 V6.0 Chapter 3 Exam Answers 2021
Posted on 25-Apr-2021
Telnet does not provide authentication whereas SSH provides authentication. Telnet sends a username and password in plain text, whereas SSH encrypts the username and password. The network administrator wants to configure Switch1 to allow SSH connections and prohibit Telnet connections. How should the network administrator change the displayed configuration to satisfy the requirement? Use SSH version 1. Configure SSH on a different line. Modify the transport input command. What is the effect of using the switchport port-security command? The security policy specifies that each access port should allow up to two MAC addresses. When the maximum number of MAC addresses is reached, a frame with the unknown source MAC address is dropped and a notification is sent to the syslog server. Which security violation mode should be configured for each access port?
[ VIEW ANSWER ] [ Find Similar ]
CCNA 2 V5 Routing And Switching Essentials Exam Answers
Posted on 4-Mar-2021
CCNA 2 v5. What does this letter signify? The route to network The route source was learned dynamically. That […]Continue reading Which attribute of big data involves an exponential data growth rate? True of False? Structured data is easier to analyze and store than unstructured data. What characterizes data management problems associated with big data storage?
[ VIEW ANSWER ] [ Find Similar ]
CCNA 1 Chapter 3 Exam Answers 2021 V6.0
Posted on 4-Apr-2021
Which dynamic routing protocol was developed to interconnect different Internet service providers? Which routing protocol is limited to smaller network implementations because it does not accommodate growth for larger networks?
[ VIEW ANSWER ] [ Find Similar ]
CCNA 2 (v5.0.3 + V6.0) Chapter 2 Exam Answers For Static Routing
Posted on 9-Apr-2021
The ports are disabled. The ports are placed in trunk mode. The ports stop communicating with the attached devices. All VLANs will be allowed across the trunk. Only the native VLAN will be allowed across the trunk. Which command should the network administrator implement to prevent the transfer of DTP frames between a Cisco switch and a non-Cisco switch? S1 config-if switchport mode trunk S1 config-if switchport mode dynamic desirable S1 config-if switchport mode access S1 config-if switchport trunk allowed vlan none Under which two occasions should an administrator disable DTP while managing a local area network? In a basic VLAN hopping attack, which switch feature do attackers take advantage of? Statically configure all ports that connect to end-user host devices to be in trunk mode. Disable DTP autonegotiation on end-user ports. All other ports are unused. Which security best practice did the administrator forget to configure?
[ VIEW ANSWER ] [ Find Similar ]
Cisco Level 2 Chapter 3 Exam Answers
Posted on 13-Apr-2021
Disable autonegotiation and set ports to either static access or static trunk. Match the IEEE Not all options are used. Question Answer A network administrator is determining the best placement of VLAN trunk links. Which two types of point-to-point connections utilize VLAN trunking? The command will have no effect on the switch. VLAN 20 will be created automatically. An error message would be displayed. Which command is used to remove only VLAN 20 from a switch? What is the effect of issuing a switchport trunk allowed vlan 30 What is the problem? The native VLAN is being pruned from the link. The trunk has been configured with the switchport nonegotiate command.
[ VIEW ANSWER ] [ Find Similar ]
CCNA 2 (v + V) Chapter 2 Exam Answers For Static Routing - Config Router
Posted on 11-Apr-2021
What are three primary benefits of using VLANs? Choose three. Refer to the exhibit. Which statement is true concerning VLAN tagging of the frame? A VLAN tag is added when the frame is accepted by the switch. No VLAN tag is added to the frame. Enter the no vlan 2 and the vlan 3 commands in global configuration mode. Enter the switchport access vlan 3 command in interface configuration mode. Enter the no shutdown in interface configuration mode to return it to the default configuration and then configure the port for VLAN 3. The network technician finds it necessary to clear all VLAN information from the switch in order to incorporate a new network design.
[ VIEW ANSWER ] [ Find Similar ]
RSE CCNA 2 Chapter 3 Quiz Answers - CCNA 7 Exam Answers
Posted on 4-Apr-2021
What should the technician do to accomplish this task? Erase the startup configuration and reboot the switch. Erase the running configuration and reboot the switch. Delete the startup configuration and the vlan. Which two characteristics match extended range VLANs? Choose two. They are commonly used in small networks. What happens to switch ports after the VLAN to which they are assigned is deleted? The ports are disabled. The ports are placed in trunk mode. The ports stop communicating with the attached devices.
[ VIEW ANSWER ] [ Find Similar ]
#CCNA2Chapter3ExamAnswers #DynamicRouting #ConfigRouter | Exam Answer, Ccna, Exam
Posted on 7-May-2021
All VLANs will be allowed across the trunk. Only the native VLAN will be allowed across the trunk. Which command should the network administrator implement to prevent the transfer of DTP frames between a Cisco switch and a non-Cisco switch? S1 config-if switchport mode trunk S1 config-if switchport mode dynamic desirable S1 config-if switchport mode access S1 config-if switchport trunk allowed vlan none Under which two occasions should an administrator disable DTP while managing a local area network? In a basic VLAN hopping attack, which switch feature do attackers take advantage of? Statically configure all ports that connect to end-user host devices to be in trunk mode. Disable DTP autonegotiation on end-user ports. All other ports are unused. Which security best practice did the administrator forget to configure? Disable autonegotiation and set ports to either static access or static trunk.
[ VIEW ANSWER ] [ Find Similar ]
CCNA 2 V Chapter 3 Exam Answers
Posted on 6-Apr-2021
Which type of route will require a router to perform a recursive lookup? Which route is the best match for a packet entering a router with a destination address of The router must send a packet to network Which route will be used to forward the traffic? What is different between IPv6 routing table entries compared to IPv4 routing table entries? IPv6 routing tables include local route entries which IPv4 routing tables do not. By design IPv6 is classless so all routes are effectively level 1 ultimate routes. IPv6 does not use static routes to populate the routing table as used in IPv4. Match the dynamic routing protocol component to the characteristic. Not all options are used. Match the characteristic to the corresponding type of routing.
[ VIEW ANSWER ] [ Find Similar ]
I'm Not A Bot. Continue.
Posted on 20-Apr-2021
Accounting can only be enabled for network connections. Users are not required to be authenticated before AAA accounting logs their activities on the network. Accounting is concerned with allowing and disallowing authenticated users access to certain areas and programs on the network. Possible triggers for the aaa accounting exec default command include start-stop and stop-only.
[ VIEW ANSWER ] [ Find Similar ]
RSE CCNA 2 Chapter 3 Quiz Answers - ICT Community
Posted on 27-May-2021
The locked-out user failed authentication. The locked-out user stays locked out until the interface is shut down then re-enabled. The locked-out user should have used the username admin and password Str0ngPa55w0rd. The locked-out user is locked out for 10 minutes by default. The router outputs accounting data for all outbound connections such as SSH and Telnet. The router collects and reports usage data related to network-related service requests. The router provides data for only internal service requests. The router outputs accounting data for all EXEC shell sessions.
[ VIEW ANSWER ] [ Find Similar ]
No comments:
Post a Comment